Mat and Pit Grating is ideal for applications where containment and collection of dirt, sludge, or liquid is required and appearance is an important factor. This grating, which accepts narrow heel traffic, is typically installed into a recess so that the top of the grating is flush with the floor. Both mat and pit grating can be ordered with a frame to simplify installation.
Product Information
Mat grating is intended to be installed, so that the grating cross bars rest on the bottom of the recess. When properly installed, Mat grating is supported across its entire width and length, eliminating any substantive deflection of the grating. This allows mat grating to be typically lighter in weight and lower in cost than Pit grating.
In contrast, Pit grating is only supported by a ledge built around the outer edges of the recess, similar to a trench application. Since Pit grating is not fully supported, it requires higher load carrying capacity than Mat grating for comparable widths and lengths.
An available frame can simplify construction of the recess. It allows for perfect sizing of the recess dimensions and forms the ledge on which Pit grating can be supported. When the grating is installed in the recess, there will be an opening along the outer edges where the grating and recess meet. A optional one-inch flange can also be ordered to cover this opening.
Flange Shown
Special Order Only
Mat and Pit Series
McNICHOLS
Mat and Pit products are divided into two series: M and P. Each series has a different height, as shown below and each is available with or without a 1-inch flange.
Mat (M) & Pit (P) Series
M Series
P Series
Without Flange
Without Flange
With Flange
With Flange
ADA Information
McNICHOLS
offers a wide selection of ADA products which meet the
ADA Requirements for Spacing
when installed in compliance with guidelines.
Last Updated about 4 years
