Nominal Inside: 54" x 36" Outside: 60 3/4" x 37 1/2" Pit Roughing-In: 61 1/4" x 38"
The unit is molded with an integral seat and a shampoo/soap shelf centered on the back wall. Shower modules shall be pre-drilled for a valve and a handheld shower head when factory supplies components. All units have an anti-skid floor treatment. The unit shall be installed in a pit, 1 3/4" deep so that the finished floor will be level with the top of the threshold. Unit must be set in a mortar base leveled and any clearances between the pit opening and the unit be filled with mortar. Shimming is necessary. It is recommended that a floor drain at or near the entrance to the shower be included. The factory supplied components are to include one stainless steel full wrap around grab bar, two stainless steel vertical grab bars, and a stainless steel curtain rod. The unit is thermoformed from continuous cast acrylic sheet into a one piece seamless unit. The unit is reinforced with a composite matrix. The unit has a backside fire rating of "A" and a flame spread of 25.